The housing for your chickens can be as simple or as fancy as your imagination and budget allow. The birds dictate the basic criteria.
Do you want a chicken coop that will make every chook for miles around the green with envy? Here’s a great looking coop that will protect your chooks from predators and bad weather. Build your backyard chickens a cordwood chicken castle!
Cordwood construction is an old and straightforward building technique that makes use of wood and mortar. It’s really simple – instead of bricks or stones, wood is set in a bed of mortar which is slightly smaller than the width of the wood. Put more mortar around and over the wood, and repeat the process until you’ve completed your walls.
While it sounds really easy and simple, we do recommend doing some research and reading before doing it yourself. Lots of details need to be considered to be able to build a good structure using cordwood. For one, the walls of a cordwood structure generally need to be around 12 to 18 inches thick. For people with a small backyard, this dimension can be a bit too much. But depending on the size of your chicken coop and yard, you might be able to build a cordwood castle with six-inch walls. Again, make sure you do enough research and ask people who are knowledgeable on this subject. 🙂
See more examples of a cordwood chicken coop by viewing our album below. And if you want to learn more about the building process of the featured cordwood chicken coop above, you can head over to the link at Backyard Chickens!
- 2×6 Lumber
- 6×6 Lumber Posts
- 2×4 Lumber
- Carriage Bolts
- Door Hinges
- Deck Screws and Nails
- Cement Mixing Tub or Wheelbarrow (for mixing mortar)
- Mortar Mix
(Mortar Mix Ingredients)
- 9 part sand
- 6 part Lime
- 6 part Sawdust
- 2 part Portland Cement
- Water (until “wet snowball” consistency is achieved)
- Measuring Tape
- Circular Saw
- Belt Sander
- Spirit Level
- Cordless Power Drill
Click on any image to start the lightbox display. Use your Esc key to close the lightbox.
Thanks to Backyard Chickens for this great project. You can get step-by-step instructions here…